i-CON 2 V MK2 soldering station with SD slot for firmware update, data interface and i-Tool soldering iron, compatible with all Vario tools

Contents
– 120 W electronic station with data interface
– i-Tool 150 W antistatic soldering iron (0105CDJ)
ERSADUR chisel soldering tip 1.6 mm (0142CDLF16)
holder (0A59)
interface for connection to ERSA filter units and heating plate

Innovative solution for intelligent hand soldering and solder fume extraction
With the i-CON 2V MK2, ERSA has developed a combination soldering station that meets the requirements for the higher working temperatures and increasingly smaller process windows of lead-free soldering processes. The (optional) ERSA solder fume extraction units (EA 110 plus i, EA55 and EA1&2) are switched off 3 seconds after the i-tool enters standby mode. In addition, you can use the interface to connect and control a heating plate (e.g. 0IRHP100A-03). The electronics station has a second port for another i-tool or, alternatively, for tools for desoldering SMD or wired components. The i-CON series is, of course, antistatic.
A firmware update can be carried out via the micro SD card slot.

Innovative technology – highlights at a glance:
· User-friendly “one-touch” software operation with online help and easy menu navigation using i-Op menu selection. Large multifunction display.
Three power levels are available, which regulate the heating element depending on the heat requirement. At the highest setting, the system delivers a maximum output of 150 W. At the low power level, the power is tightly regulated and no temperature overshoot is allowed.
Process window and alarm visually and audibly inform the operator if the temperature leaves the pre-set temperature process window.
· With the i-Set Tool Vario option, further i-CON soldering stations can be automatically configured and locked. The station settings can be quickly and easily downloaded from an i-CON to the i-Set Tool – like a USB stick – and applied to another station within 5 seconds.

i-Tool
The i-Tool is an extremely light, powerful fine soldering iron with a wide selection of affordable permanent soldering tips. 150 W power ensures the fastest heat-up and cool-down times. Process window alarm, energy power levels and automatic standby sensor give i-CON users an unprecedented level of process control.
The i-Tool’s calibration data is stored on the printed circuit board in the soldering iron handle. This calibration is independent of the control station, so all i-Tools can be calibrated at a central location.
The integrated Tip’N’Turn bayonet lock ensures that tips can be changed quickly and easily and also improves performance by 20-25% compared to a screw connection.

The ERSA filter units can be connected to the i-Con 2V C MK2 (with interface) version so that the standby signal is transferred to the filter. This then shuts down at the same time as the station. In addition, you can connect and control a heating plate (e.g. 0IRHP100A-03) using the interface.

– Energy consumption in standby approx. 20W