ERSA VARIO2 MK2, ESD 2-channel soldering and hot air station with AIR-TOOL 200W, auto-standby

Description

ERSA i-CON VARIO 2 MK2 Multi-channel soldering and desoldering station 200W

Scope of delivery
– 200W antistatic electronics station, air volume 2-20l/min (0ICV2035A)
– i-Tool AIR S 200W hot air pencil (0470ERJ)
– Hot air tip, 3.5 mm diameter 50-550°C (0472ER)
– Storage stand (0A55)

The i-CON VARIO 2 MK2 multi-channel soldering and desoldering station provides professional soldering users with two soldering tools that can be used simultaneously. In parallel to the new, ergonomic hot air clamp i-Tool AIR S (200 W), the 150 W i-Tool can be used to operate another soldering tool for conventional soldering or the new
Chip Tool Vario desoldering tweezers (80 W).
are further Ersa soldering tools. The compact, ESD-safe supply unit offers the same simple and clear operability as usual in the i-CON family. Interfaces to Ersa solder fume extraction units and preheating plates are just as much a matter of course as the simple and safe configuration of the station via a microSD memory card.
The current firmware versions can be viewed and downloaded at any time from http://www.ersa.de/vario
.

i-Tool-AIR S
Ergonomically handy, powerful! This is how the i-tool AIR S can be aptly described. The slim and light handpiece carries a 200 W heating cartridge, allowing fatigue-free work on a wide range of SMD components. The hot air volume can be easily adjusted directly on the handpiece; the respective air volume (2 to 20 l/min) can be clearly seen on the display of an i-CON VARIO 2 or 4. The air volume can be precisely adjusted even when soldering the smallest chip resistors. Various nozzles can be used to optimally heat the components. A motion sensor ensures that the hot air automatically switches off after a programmable time during work breaks.
The i-Tool-AIR S is switched on and off using the light sensor in the handpiece.

– Energy consumption in standby approx. 25W